ATmega328P Microcontroller Chip w/ Arduino Bootloader Installed

Product ID: 107
Atmega328 microcontroller with arduino bootloader installed
$4.99 Out of Stock

Out of Stock

No worries, we can notify you when this item is back in stock. Please enter your email.

You will be notified about this product only!

So you are done prototyping on an Arduino Uno and want to make your project more compact? ATMega328P microcontroller chip with a pre-installed Arduino bootloader will get you up rolling. This is the same DIP chip that powers an Arduino Uno.

Hook in a 16 MHz crystal along with a couple of 20pF capacitors, a power supply and you have a setup ready to put in the project. To program the chip, your can either put it in an Arduino Uno's DIP socket or provide a serial interface and then program it with something like an AVR Programmer or an FTDI cable.If you wanty to program the chip then you should select the Arduino UNO board within the Arduino IDE tools menu.

Specification

MicrocontrollerATmega328P High Performance, Low Power AVR® 8-Bit Microcontroller
Clock Speed0 to 20MHz at 1.8 to 5.5V (16 MHz on Arduino Uno Board)
Flash Memory32 KB
EEPROM1 KB
SRAM2 KB
Write Erase Cycles10,000 Flash / 100,000 EEPROM
Operating Voltage1.8 to 5.5V
Operating Temperature- 40° C to 85° C
Data Retention20 years at 85° C to 100 years at 25° C
I/O Pins28-pin PDIP