Rugged Metal On/Off Switch with Red LED Ring - 16mm

Product ID: 1409
Rugged metal on slash off switch with red led 2437104063
  • Rugged metal on slash off switch with red led 2437104063
  • Rugged metal on slash off switch with red led 1441334949
  • Rugged metal on slash off switch with red led 3041181514
$6.99 Out of Stock

Out of Stock

No worries, we can notify you when this item is back in stock. Please enter your email.

You will be notified about this product only!

These chrome-plated metal buttons are rugged and look real good while doing it! Simply drill a 16mm hole into any material up to 1/2" thick and you can fit these in place, there's even a rubber gasket to keep water out of the enclosure. On the front of the button is a flat metal actuator, surrounded by a red plastic LED ring. On the back there are 3 contacts for the button (common, normally-open and normally-closed) and 2 for the red LED ring (+ and -). Connect 3 to 6V to the LED to have it light up nicely, there's a built in resistor! If you want to use this with a higher voltage, say 12V or 24V, simply add a 470 ohm resistor in series with the LED connection to keep the LED current at around 20mA.

This button is an on/off switch button, when you press it the 'normally-open' contact shorts to the common contact and the button stays 'pressed'. When you press it a second time, the button springs open, and the contacts open up again.

The switch and LED are separated, so you could wire it to turn on when pressed or vice versa or whatever you wish! Check the tech details for information!


Specification

Lamp rated voltage6V
Panel thickness1-13mm
Drill hole diameter16mm
Switch Ratings3A / 250VDC
Switch contacts 1 NO, 1 NC
Contact resistance50 m-Ω
Insulation resistance1000 M-Ω
Temperature -20 C to +55 C
Operating pressure1.5 - 2.5 N
Operating stroke2mm
Electrical life50,000 Operations
Mechanical life500,000 Operations
MaterialChrome plated brass