Panel Mount Ethernet Extension Cable

Product ID: 1466
Panel mount ethernet extension cable 5753061626
  • Panel mount ethernet extension cable 5753061626
  • Panel mount ethernet extension cable 5425933436
  • Panel mount ethernet extension cable 6719455302
  • Panel mount ethernet extension cable 7726885004
  • Panel mount ethernet extension cable 5782704210
$6.99 Out of Stock

Out of Stock

No worries, we can notify you when this item is back in stock. Please enter your email.

You will be notified about this product only!

This handy Ethernet extension cable will make it easy for you to enclose a device that has an Ethernet port. We think this would be most useful when putting a Beagle Bone, Raspberry Pi, Arduino Ethernet into a box.

The jack half has two mounting 'ears' with 4-40 screws installed, 1" inch / 25mm apart. The ears are flexible so the holes don't have to drilled very precisely. Can be used with box walls up to 0.25" wide. The screws can be put on from the back for 'reverse' mounting if the box thickness is a problem. Entire unit is 12" long (9" cabling between jack and RJ45 Ethernet connector).

  • Technical Drawing for this cable
  • Panel mount Ethernet 8P socket with Ethernet 8P plug at cable end. Straight-through extension
  • CAT 5e
  • 24 AWG wires
  • Plastic "boot" at Ethernet end is 20mm tall x 33mm wide (20mm where it is smaller behind the mounting flange) x 28mm deep

Specification

Length (Tip to Tip)31 cm
Length (jack to connector)23 cm
Mounting Screw spacing24mm (2 mounting screws 4-40 of 10mm)