Ethernet Shield for Arduino - W5500 Chipset

Product ID: 1024
Ethernet shield for arduino number 1
  • Ethernet shield for arduino number 1
  • Ethernet shield for arduino number 2
  • Ethernet shield for arduino number 3
  • Ethernet shield for arduino number 4
$81.99 Out of Stock

Out of Stock

No worries, we can notify you when this item is back in stock. Please enter your email.

You will be notified about this product only!

The W5500 Ethernet Shield v1.0 can be used to provide your projects with internet connectivity.W5500 enables users to have the Internet connectivity in their applications just by using the single chip in which TCP/IP stack, 10/100 Ethernet MAC and PHY embedded. The shield also have two Grove connectors and a microSD card socket to support projects which require storing large amounts of data from Grove sensor. The RJ45 port (Where the Ethernet cable is connected to) is low enough to allow you to stack more shields on top of this one if needed.

  • Supports Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
  • Supports 8 independent sockets simultaneously
  • Supports Power down mode
  • Supports Wake on LAN over UDP
  • Supports High Speed Serial Peripheral Interface(SPI MODE 0, 3)
  • 10BaseT/100BaseTX Ethernet PHY embedded
  • Supports Auto Negotiation (Full and half duplex, 10 and 100* based )
  • Not supports IP Fragmentation
  • Micro-SD card socket
  • Grove connector for I2C and UART

Specification

Supported TCP/IP Protocols TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
Internal memory for TX/RX buffers 32Kbytes
Weight 25 g
Dimensions 71.0mm x 53.0mm x 23.0mm
Operating Voltage 3.3V operation with 5V I/O signal tolerance
LED outputs Full/Half duplex, Link, Speed, Active

Related